The following specifications are for our standard unit. If you need assistance designing a non-standard elevator or are unsure if this is the right equipment for your particular job, be sure to contact our sales department at 1-800-333-5148.
Our friendly, knowledgeable sales team will be happy to help you design the perfect elevator to get the job done right!
Head Bearings: All pillow block designs: Ball, Double Row Spherical and SAFl
Take Ups: Screw type take-ups with heavy-duty pillow block bearings
Shafts: 1045 turned, ground and polished special alloy steel
Belting: Static conductive, super oil-resistant and fire-retardant rubber covered belt
Pulleys: Balanced crowned face welded steel
Lagging: Slide lag
Buckets: Heavy-duty, high density, non-sparking polyethylene
Wear Points: Urethane lined discharge
Construction: Boot - 7 GA or 1/4", Head - 11 GA, Casing - 11 GA
Casing: 10' towered continuously jig welded with continuously welded end flanges
Finish: Primed then acrylic enamel finish coat applied
Drive Mount: Motor support base is standard. Drive guard standard
Vents: Blowout vent at head
Access: 10' inspection section with three inspection ports, head access and inspection doors
Throat Wiper: Adjustable rubber throat wiper plate
Clean-Out: Hand type clean-out slides
Options & Accessories:
198 Commerce Drive
Need more information? Fill out the form below and an AGI representative will connect with you.