The mTS015 is a solid state digital single wire temperature sensor in a threaded brass housing.

The brass temperature sensor is accurate to 0.5°C over the –10°C to +85°C (14°F to 185°F) temperature range, and is usable from -67°F to +257°F (-55°C to +125°C).

Straightforward to install in the field with no calibration required. Typically this brass temperature sensor is used as a rub sensor in part of a brass rub block assembly to detect belt misalignment on conveyors and bucket elevator legs.

• 3/8” x 16 threaded brass rod, complete with single jam nut
• Brass housing is standard - stainless steel is available, consult the factory
• 6’ (2m) of durable UL 2517 TPE cable with UV protection
• Intrinsically Safe when used with the mBC083 Bus Converter
• Each sensor has a unique permanent digital address
• RJ11 modular jack for easy connection to CMC Field Interconnect Box (FIB)
• No calibration required

Product Description

The mTS015 is a digital single-wire temperature sensor enclosed in a threaded brass rod for use in harsh environments. The mTS015 sensor’s recommended operating range is -40°F to +225°F (-40°C to +105°C) and it is rated as Intrinsically Safe when used with the mBC083 Bus Converter. The temperature sensor uses a single-wire data communications bus. Up to 32 sensors can be connected in parallel to a single Bus Converter.

The sensor bus has a fully specified cabling system complete with terminal assembles and uses low cost CAT5 cabling and punch down blocks for easy termination. Each sensor has a unique serial number identifying it to the Bus Converter. No sensor calibration is required.

Typical Applications

Temperature sensing on rub blocks used on belt conveyors and bucket elevators.

Contact Us

Need more information? Fill out the form below and an AGI representative will connect with you.